Products
ISD-410-MP Industrial Managed POE+ Ethernet Switch
10 x 10/100/1000 Base T(X) of which 8x PoE+ capable
4 x 100/1000 Base-F(X) SFP ports
redundant power supply with 12-57 VDC and reverse polarity protection, 6KV overvoltage protection
Extended operating temperature range -40°C to +80°C
IPV4/IPV6 dual-stack protocol
TACACS+, ACL, IEEE 802.1X, HTTPS and SSH
supports 9K jumbo frames
G.8032 ERPS, Ring Protection (< 20 ms) Spanning Tree (STP, RSTP & MSTP)
Port-based /Tag-based VLAN, IEEE 802.1ad/QinQ VLAN and protocol-based VLAN
Intelligent PoE power supply, PoE network management and Fast Ethernet switch with ring function
The DigiComm ISD-410-MP switches offer 10 x Gigabit Ethernet and 4 Gigabit SFP ports. These ports can be equipped with any SFP modules, e.g. fiber optics (single mode, multimode, RJ-45, VDSL), for individual adaptation to your own network and thus ensure a wide range of applications.
The support of 10/100/1000 Base-T(X) and 100/1000 Base-F(X) Gigabit ports makes the DigiComm ISD-410-MP suitable for use in complex high-speed networks, which are optimized for high data throughput or low latency.
The ISD-410-MP has 8x 10/100/1000 Base-T(X) POE+ ports which support the IEEE802.3af/at standard and can deliver up to 30W per port (max.120W).
This ISD switch has a redundant DC power supply of 12-57VDC (48-57VDC for POE applications), an IP40 protected aluminum housing and is suitable for DIN rail mounting.
Depending on the requirement profile, the DigiComm ISD series is available in a manageable Layer2 or unmanaged version. With VLAN, SNMP v1/v2 and v3, HTTPS, IGMP v1/v2 all important and security relevant protocol standards are supported.
Ports
8x 10/100/1000Base-T PoE ports (data/power)
2x 10/100/1000Base-T RJ45 port (data)
4x 100/1000Base-X SFP fiber slot port (data)
1x RS-232 console port (115200,N,8,1)
Copper RJ-45 ports
Speed: 10/100/1000 Mbps
MDI/MDIX auto-crossover: Supports 1:1 and cross cable
Auto-negotiation: 10/100/1000 Mbps speed auto-negotiation; full and half duplex
SFP (pluggable) ports
SFP ports: SFP ports 100/1000 Base-F(x) SFP slot
Fiber port (connector): LC (but depending on the selected SFP module)
POE ports
Max 30W per port; IEEE802.3af/at
Network redundancy
DigiComm Ring protection: Link loss recovery < 20m
Spanning Tree Protocol: IEEE 802.1D STP, IEEE 802.1w RSTP, IEEE 802.1s MSTP
Port Trunk with LACP Static trunk or Dynamic via LACP (Link Aggregation Control Protocol)
General
DIN rail mounting
IP Standard: IP40
Redundant voltage: 12~57VDC
Max. Power consumption: 30W
Temperature: -40 to +80°C (operating)
Humidity: 5-90
RoHS (lead-free)